A practical reference on counterion: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-02-10 and is reviewed periodically as new material appears.
The mechanisms attributed to semax are inferred from animal and cell studies rather than traced to one confirmed target. The most frequently cited pathway involves increased expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal and cortical tissue. Some work points to engagement of melanocortin receptors, particularly MC4, which the parent ACTH fragment can activate. Effects on dopaminergic and serotonergic signalling have also been reported. No single account explains all observed results, and the relative weight of each pathway remains unsettled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. The first four residues correspond to the ACTH(4-10) fragment, while the terminal Pro-Gly-Pro extension was added to improve metabolic stability. Its molecular formula is C37H51N9O10S and its monoisotopic mass is approximately 813.9 Da. The compound is classified as a peptide research chemical and as a registered pharmaceutical product in Russia, but it does not hold marketing approval in the European Union or the United States. Naming conventions vary across supplier catalogs.
Development of the compound took place in the Soviet Union during the 1980s, largely through peptide research groups affiliated with the Shemyakin-Ovchinnikov Institute and Moscow State University. Investigators screened fragments of adrenocorticotropic hormone for activity on the central nervous system while attempting to separate cognitive effects from hormonal ones. The shortened sequence was selected because it retained behavioral activity in animal models without stimulating corticosteroid release. Early publications described the molecule as an ACTH(4-10) analog.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized solid from research suppliers |
| Solubility | Freely soluble in water | Also dissolves in aqueous buffers; solutions are used fresh |
| Typical storage temperature | -20 °C for lyophilized powder | Short-term transport at 2-8 °C is common |
| Common analytical method | Reverse-phase HPLC | Paired with mass spectrometry for identity confirmation |
| Common synonyms | ACTH(4-10) analogue; MEHFPGP | N-terminal methionine retained in the chain |
Quality documentation for research-grade peptide usually includes a certificate of analysis stating purity, identity, and residual counterion content. Batch-to-batch variation in purity and salt form is a recognized issue, and comparisons across suppliers require attention to the exact counterion, for example acetate versus trifluoroacetate. Sequence verification by tandem mass spectrometry provides stronger evidence than a single mass measurement. For any study reporting biological results, the analytical method and the measured purity should be stated explicitly. Independent verification of supplier claims is considered good practice.
Semax is supplied as a lyophilized powder that appears white to off-white. It dissolves readily in water, phosphate-buffered saline, and other aqueous media, which simplifies preparation of working solutions for laboratory use. The nasal products registered in Russia are dilute aqueous solutions, typically around 0.1 percent peptide by weight. Organic solvents are rarely necessary and can complicate handling. Because the peptide is hygroscopic, weighing should be performed quickly and with minimal exposure to ambient humidity.
Semax is a synthetic heptapeptide developed in the Soviet Union during the 1980s by researchers at the Institute of Molecular Genetics in Moscow. It was designed as a truncated analog of adrenocorticotropic hormone, retaining only the fragment spanning residues four through ten. Investigators sought a peptide that would preserve the cognitive effects associated with ACTH while eliminating the hormonal stimulation of the adrenal cortex. The compound entered clinical use in Russia during the following decade.
Russian regulatory authorities approved the peptide for nasal administration, and it remains listed in the national pharmacopoeia under several trade names. Documented indications include acute ischemic stroke, transient ischemic attacks, traumatic brain injury, and certain ophthalmological and neurological conditions. Physicians also prescribe it for cognitive complaints in older patients, although the evidence base for that use is thinner. Outside Russia and a few neighboring states, the substance is not an approved medicine and is sold instead as a research chemical.
Later generations of the molecule include an N-acetylated form and an amidated form, both marketed online alongside the parent peptide. These variants differ in terminal chemistry and stability, and they are frequently discussed in the same breath even though they have not been compared in controlled trials. Supply outside formal healthcare systems comes largely from laboratories that synthesize peptides to order. Purity and identity of these materials vary widely, and no single body oversees the international trade.
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
多数实验室与市售的 Semax 以冻干粉形式提供。冻干粉通常建议保存在 -20 °C 或更低温度下，同时避免光照与反复升温。短期运输有时采用冷藏条件，但长期保存仍以冷冻为主。分包操作应尽量减少开盖次数，以降低吸湿和微生物污染的风险。开封后若未一次用完，建议在干燥环境中密封并尽快放回低温储存。
=== Use of methylene chloride === Merck & Co. once used methylene chloride, a "priority pollutant" on the United States Environmental Protection Agency's list of pollutants and an animal carcinogen. It was used as a solvent in the manufacturing process for imipenem, an ingredient of the antibiotic Primaxin. Merck chemists and engineers subsequently replaced the compound with others having fewer negative environmental effects. Merck has also modified its equipment to provide greater control over its manufacturing process. Biological oxygen demand was reduced by 75%.
Thus, irisin was found to positively regulate the expression of BDNF and negatively influence the levels of GHbA1c (human glycated hemoglobin A1c) and AGEs, suggesting that irisin influences cognitive dysfunction in rats with type 2 diabetes by regulating the expression of BDNF and glycometabolism. It appears that these proteins are connected and related to each other in terms of cardiovascular/metabolic diseases, such as hypertension and diabetes.
American Samoa - Scouting in American Samoa - Aloha Council of the Boy Scouts of America Guam - Scouting in Guam - Aloha Council of the Boy Scouts of America Northern Marianas Islands - Scouting in the Northern Mariana Islands - Aloha Council of the Boy Scouts of America Puerto Rico - Puerto Rico Council of the Boy Scouts of America United States Virgin Islands - Scouting in the United States Virgin Islands is the responsibility of National Capital Area Council of the Boy Scouts of America Antarctica
Sources: en.wikipedia.org
Adults typically range from 120 to 188 cm (47 to 74 in) in head-and-body length, and 63 to 103.5 cm (24.8 to 40.7 in) in shoulder height. Although the American black bear is the smallest bear species in North America (smaller than the brown and polar bears), large males exceed the size of other bear species in other continents. Weight tends to vary according to age, sex, health and season. Adult males typically weigh between 60–300 kg (130–660 lb) with females averaging between 33% and 50% less at 40–150 kg (88–331 lb). Seasonal variation in weight is very pronounced: in autumn, their pre-den weight tends to be 30% higher than in spring, when black bears emerge from their dens. Bears on the East Coast tend to be heavier on average than their West Coast counterparts, although they typically follow Bergmann's rule regarding average size being inversely correlated with environment temperature, and bears from the northwest are often slightly heavier than the bears from the southeast. In California, studies indicate that the average adult mass is 86 kg (190 lb) in males and 58 kg (128 lb) in females. Adults in Yukon Flats National Wildlife Refuge in east-central Alaska were found to average 87.3 kg (192 lb) in males and 63.4 kg (140 lb) in females, whereas on Kuiu Island in southeastern Alaska (where nutrient dense salmon are readily available) adults averaged 115 kg (254 lb). In Great Smoky Mountains National Park, adult males averaged 112 kg (247 lb) and adult females averaged 47 kg (104 lb) per one study.
Most SDS-PAGE protein separations are performed using a "discontinuous" (or DISC) buffer system that significantly enhances the sharpness of the bands within the gel. During electrophoresis in a discontinuous gel system, an ion gradient is formed in the early stage of electrophoresis that causes all of the proteins to focus on a single sharp band in a process called isotachophoresis. Separation of the proteins by size is achieved in the lower, "resolving" region of the gel. The resolving gel typically has a much smaller pore size, which leads to a sieving effect that now determines the electrophoretic mobility of the proteins.
=== Thermoresponsivity in water === Polymer solutions that show thermoresponsivity in water are especially important since water as a solvent is cheap, safe and biologically relevant. Current research efforts focus on water-based applications like drug delivery systems, tissue engineering, bioseparation (see the section Applications). Numerous polymers with LCST in water are known. The most studied polymer is poly(N-isopropylacrylamide). Further examples are poly[2-(dimethylamino)ethyl methacrylate] (pDMAEMA) hydroxypropylcellulose, poly(vinylcaprolactam), poly-2-isopropyl-2-oxazoline and polyvinyl methyl ether. Some industrially relevant polymers show LCST as well as UCST behavior whereas the UCST is found outside the 0-to-100 °C region and can only be observed under extreme experimental conditions. Examples are polyethylene oxide, polyvinylmethylether and polyhydroxyethylmethacrylate. There are also polymers that exhibit UCST behavior between 0 and 100 °C. However, there are large differences concerning the ionic strength at which UCST behavior is detected. Some zwitterionic polymers show UCST behavior in pure water and also in salt-containing water or even at higher salt concentration. By contrast, polyacrylic acid displays UCST behavior solely at high ionic strength. Examples for polymer that show UCST behavior in pure water as well as under physiological conditions are poly(N-acryloylglycinamide), ureido-functionalized polymers, copolymers from N-vinylimidazole and 1-vinyl-2-(hydroxylmethyl)imidazole or copolymers from acrylamide and acrylonitrile.
=== Classification of metal ions === Ahrland, Chatt and Davies proposed that metal ions could be described as class A if they formed stronger complexes with ligands whose donor atoms are nitrogen, oxygen or fluorine than with ligands whose donor atoms are phosphorus, sulfur or chlorine and class B if the reverse is true. For example, Ni2+ forms stronger complexes with amines than with phosphines, but Pd2+ forms stronger complexes with phosphines than with amines. Later, Pearson proposed the theory of hard and soft acids and bases (HSAB theory). In this classification, class A metals are hard acids and class B metals are soft acids. Some ions, such as copper(I), are classed as borderline. Hard acids form stronger complexes with hard bases than with soft bases. In general terms hard–hard interactions are predominantly electrostatic in nature whereas soft–soft interactions are predominantly covalent in nature. The HSAB theory, though useful, is only semi-quantitative. The hardness of a metal ion increases with oxidation state. An example of this effect is given by the fact that Fe2+ tends to form stronger complexes with N-donor ligands than with O-donor ligands, but the opposite is true for Fe3+.
Sources: en.wikipedia.org
It consists mainly of animal experiments and small clinical reports, with much of the clinical material published in Russian-language journals. Large independent trials are scarce. Separating reliable effects from chance findings is consequently difficult.
A fraction of an intranasal dose is thought to reach the central nervous system, and this route is favoured partly for that reason. The proportion is not well characterized. Direct measurement in humans remains difficult with current methods.
Raised BDNF and NGF expression has been reported across several animal studies, which makes the signal fairly consistent. Whether the same change occurs in humans at usable doses is not established. It is best treated as a working hypothesis rather than a confirmed clinical mechanism.
It is a synthetic peptide of seven amino acids. Its backbone corresponds to a fragment of adrenocorticotropic hormone extended at the carboxyl end. The material is distributed as a lyophilized solid for laboratory use.