Everything below concerns Methionine oxidation. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-02-04. Where a claim depends on a specific study, the study is described rather than over-claimed.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised solid |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers |
| Typical storage temperature | -20 °C | Dry, desiccated, protected from light |
| Typical analytical method | RP-HPLC with UV detection | Often paired with LC-MS |
| Water content | Reported as Karl Fischer value | Freeze-dried material is hygroscopic |
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
The mechanisms attributed to semax are inferred from animal and cell studies rather than traced to one confirmed target. The most frequently cited pathway involves increased expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal and cortical tissue. Some work points to engagement of melanocortin receptors, particularly MC4, which the parent ACTH fragment can activate. Effects on dopaminergic and serotonergic signalling have also been reported. No single account explains all observed results, and the relative weight of each pathway remains unsettled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Supraphysiological levels of dihydrotestosterone (DHT) occur with scrotal application of testosterone, whereas this does not occur with non-scrotal transdermal application. This is due to the high expression of 5α-reductase in scrotal skin. Estradiol levels are similar with scrotal versus non-scrotal application of transdermal testosterone. Low-dose transdermal testosterone patches in women have been found to result in testosterone levels of 64 ng/dL with 150 μg/day and 102 ng/dL with 300 μg/day. When testosterone is used transdermally in women or trans men, hair growth at the application sites can happen.
==== European guidelines for phenylketonuria ==== The consensus paper was picked up by the Scientific Advisory Committee of the E.S.PKU. The SAC launched an expert group, the creation the first European Guidelines for Phenylketonuria. This led to the first publication of the key statements in the lancet diabetes and endocrinology. By the end of the year, the complete guidelines were published in the Orphanet Journal of Rare Diseases. The publication also received some critical attention from other medical professionals. A second version of the guidelines is already been worked on.
This album cover... I like to refer to it as "revenge". The song 'Dirt' was written to a certain person who basically buried my ass, so the woman on the album cover is kinda the portrayal of that person being sucked down into the dirt (laughs), instead of me. The picture is the spitting image of her, and that wasn't even planned. Actually, I was pretty angry about it when I first saw it – she's not happy about it either (laughs). It was real eerie. The cover was referenced on the music video for Alice in Chains' 2009 single "A Looking in View". At the 6:55 mark of the video, a woman (played by Sacha Senisch) is seen lying on a cracked desert floor similarly to Dirt's cover. "A Looking in View" was featured on Alice in Chains' fourth studio album, Black Gives Way to Blue, released exactly 17 years after Dirt, on September 29, 2009.
Sources: en.wikipedia.org
Nickel-56, also doubly magic, is produced in large quantities in supernovae. In the last phases of stellar evolution of very large stars, fusion of lighter elements like hydrogen and helium comes to an end. Later in the star's life cycle, elements including magnesium, silicon, and sulfur are fused to form heavier elements. Once the last nuclear fusion reactions cease, the star collapses to produce a supernova. During the supernova, silicon burning produces 56Ni. This isotope of nickel is favored because it has an equal number of neutrons and protons, making it readily produced by fusing two 28Si atoms. 56Ni is the last element that can be formed in the alpha process. Past 56Ni, nuclear reactions are endoergic and energetically unfavorable. 56Ni decays to 56Co and then 56Fe by β+ decay. The radioactive decay of 56Ni and 56Co supplies much of the energy for the light curves observed for stellar supernovae. The shape of the light curve of these supernovae display characteristic timescales corresponding to the decay of 56Ni to 56Co and then to 56Fe.
Glargine and detemir are significantly more expensive than NPH, lente and ultralente, and they cannot be mixed with other forms of insulin. A short-acting insulin is used to simulate the endogenous insulin surge produced in anticipation of eating. Regular insulin, lispro, aspart and glulisine can be used for this purpose. Regular insulin should be given with about a 30-minute lead-time prior to the meal to be maximally effective and to minimize the possibility of hypoglycemia. Lispro, aspart and glulisine are approved for dosage with the first bite of the meal, and may even be effective if given after completing the meal. The short-acting insulin is also used to correct hyperglycemia.
This work stimulated research in the area, and two years later the first NLS was identified in SV40 Large T-antigen (or SV40, for short). However, a functional NLS could not be identified in another nuclear protein simply on the basis of similarity to the SV40 NLS. In fact, only a small percentage of cellular (non-viral) nuclear proteins contained a sequence similar to the SV40 NLS. A detailed examination of nucleoplasmin identified a sequence with two elements made up of basic amino acids separated by a spacer arm. One of these elements was similar to the SV40 NLS but was not able to direct a protein to the cell nucleus when attached to a non-nuclear reporter protein. Both elements are required. This kind of NLS has become known as a bipartite classical NLS. The bipartite NLS is now known to represent the major class of NLS found in cellular nuclear proteins and structural analysis has revealed how the signal is recognized by a receptor (importin α) protein (the structural basis of some monopartite NLSs is also known). Many of the molecular details of nuclear protein import are now known. This was made possible by the demonstration that nuclear protein import is a two-step process; the nuclear protein binds to the nuclear pore complex in a process that does not require energy. This is followed by an energy-dependent translocation of the nuclear protein through the channel of the pore complex.
== External links == EDTA: Molecule of the Month EDTA Determination of Total Water Hardness Oviedo, Claudia; Rodríguez, Jaime (2003). "EDTA: The chelating agent under environmental scrutiny". Química Nova. 26 (6): 901–905. doi:10.1590/S0100-40422003000600020. hdl:10533/174687.
Sources: en.wikipedia.org
Reversed-phase high-performance liquid chromatography is the standard method, with detection in the ultraviolet range. Peak area percentage yields a purity figure for the main component. Mass spectrometry is normally run alongside to confirm molecular identity.
Dry lyophilised powder is generally kept at minus twenty degrees Celsius, protected from light and moisture. Repeated freeze-thaw cycles are avoided because they encourage aggregation and moisture uptake. Solutions are less stable than the solid form and degrade faster at room temperature.
A certificate documents what the supplier measured, not what an independent party confirmed. Methods, instruments and acceptance criteria can differ between suppliers. Third-party testing is the usual way to resolve discrepancies.
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.