This is a working overview of 反相色谱, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-12-01 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Semax is supplied as a lyophilized powder that appears white to off-white. It dissolves readily in water, phosphate-buffered saline, and other aqueous media, which simplifies preparation of working solutions for laboratory use. The nasal products registered in Russia are dilute aqueous solutions, typically around 0.1 percent peptide by weight. Organic solvents are rarely necessary and can complicate handling. Because the peptide is hygroscopic, weighing should be performed quickly and with minimal exposure to ambient humidity.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
==== Kidney ==== People with end-stage kidney disease can have chronically elevated cardiac troponin T levels, which are linked to a poorer prognosis. Troponin I is less likely to be falsely elevated.
Since 2007, Israel had implemented a strict land and sea blockade that had prevented items such as food and medicine from moving into the Gaza Strip, with the health system struggling before the war. Ahmed al-Fara, the head of pediatrics at Nasser Medical Complex in Khan Younis, stated due to the lack of water during the war, he was witnessing the "most serious epidemic of gastroenteritis" among children he had ever seen. Catherine M. Russell, the executive director of UNICEF, toured Gaza on 15 November 2023, stating many children were lacking medical care. On 28 December, UNOCHA stated 50 percent of all children in the Gaza Strip were experiencing dehydration, malnutrition, respiratory and skin diseases. Cases of diarrhea in children under the age of five has increased by about 2,000% since 7 October per a UNICEF report. A UN spokesperson indicated that between 7 October 2023 and 4 January 2024, disease had skyrocketed in Gaza with more than 400,000 cases of infectious disease reported, which included about 180,000 people with upper respiratory infections and more than 136,000 cases of diarrhea, with half of cases presenting in children under 5. By July 2024, WHO stated more than 150,000 people had contracted skin infections, with malnourished children most susceptible due to their weakened immune systems. According to statistics published by the World Health Organization (WHO), in January 2024, only about 30% of medics were still working due to the widespread effects of the war in Gaza.
Type I : Extra-dural; no nerve roots or rootlets such as intra-sacral meningoceles; probably of congenital origin developing from the dural sac to which they are connected by a little collar. They are found at the point of exit of a dorsal nerve root from the dural sac. They are sometimes difficult to identify and can be "seen" as a type II cyst on imaging. These cysts are often associated with foramina enlargement and scalloping of the vertebrae. It is very important to distinguish them from sacral meningoceles going to the pelvic area; they are often associated with other congenital abnormalities (teratomes, dermoïdes, lipomas, and other abnormalities(uro-genital and ano-rectal)) Type II: Extra-dural; nerve root present (such as Tarlov or perineural cysts). There are often not only one but multiple cysts, mostly found in the sacrum area. There are two types: Tarlov (perineural) cysts are located posteriorly to the root ganglion, with nerve fibres inside or nerve tissue in the walls; they are not communicating with the perineural arachnoid space. Type-II cysts are very small in the upper sacral area, but can be bigger (up to 3 centimetres or 1.2 inches) if found located in the lower part of the sacrum. The second variant of type-II cysts are called "meningeal diverticula". They are located anteriorly to the nerve root ganglion, with nerves fibres inside and communicating with the subarachnoid space. Type III: intra-dural; these are either congenital or caused by trauma; they are rarely associated with other abnormalities and rare in occurrence.
Sources: en.wikipedia.org
A 2005 epidemiology review concluded: "In aggregate the human epidemiological evidence is consistent with increased risk of birth defects in offspring of persons exposed to DU." Studies using cultured cells and laboratory rodents continue to suggest the possibility of leukemogenic, genetic, reproductive, and neurological effects from chronic exposure.
==== Administration of I-131 for ablation ==== Typical therapeutic doses of I-131 are between 2220 and 7400 megabecquerels (MBq). Because of this high radioactivity and because the exposure of stomach tissue to beta radiation would be high near an undissolved capsule, I-131 is sometimes administered to human patients in a small amount of liquid. Administration of this liquid form is usually by straw which is used to slowly and carefully suck up the liquid from a shielded container. For administration to animals (for example, cats with hyperthyroidism), for practical reasons the isotope must be administered by injection. European guidelines recommend administration of a capsule, due to "greater ease to the patient and the superior radiation protection for caregivers".
== Baltimore Colts == The Baltimore Colts defensive line that included future Hall of Famers defensive end Gino Marchetti and tackle Art Donovan, along with end Don Joyce and tackle Eugene "Big Daddy" Lipscomb has also been referred to as the "'fearsome foursome'" by at least 1958. They have been called the prototype of defensive lines. In addition to Marchetti’s and Donovan’s Hall of Fame status, Lipscomb was first-team All-Pro in 1958 and 1959. Marchetti is considered among the greatest defensive ends in NFL history. The Colts won the 1958 and 1959 NFL championships over the New York Giants, the 1958 game being known as "The Greatest Game Ever Played". They played together as a line from 1956 to 1960, with defensive end Ordell Braase taking over as a starter for Joyce in 1960, and Lipscomb being traded to the Steelers before the start of the 1961 season.
=== Discovery === The word "benzene" derives from "gum benzoin" (benzoin resin), an aromatic resin known since ancient times in Southeast Asia, and later to European pharmacists and perfumers in the 16th century via trade routes. An acidic material was derived from benzoin by sublimation, and named "flowers of benzoin", or benzoic acid. The hydrocarbon derived from benzoic acid thus acquired the names benzin, benzol, and benzene. Michael Faraday first isolated and identified benzene in 1825 from the oily residue derived from the production of illuminating gas, giving it the name bicarburet of hydrogen. In 1833, Eilhard Mitscherlich produced it by distilling benzoic acid (from gum benzoin) and lime. He gave the compound the name benzin. In 1836, the French chemist Auguste Laurent named the substance "phène"; this word has become the root of the English word "phenol", which is hydroxylated benzene, and "phenyl", the radical formed by abstraction of a hydrogen atom from benzene. In 1845, Charles Blachford Mansfield, working under August Wilhelm von Hofmann, isolated benzene from coal tar. Four years later, Mansfield began the first industrial-scale production of benzene, based on the coal-tar method. Gradually, the sense developed among chemists that a number of substances were chemically related to benzene, comprising a diverse chemical family. In 1855, Hofmann was the first to apply the word "aromatic" to designate this family relationship, after a characteristic property of many of its members. In 1997, benzene was detected in deep space.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Dry powder is usually kept at about -20 degrees Celsius for long-term storage and at 2 to 8 degrees Celsius for short working periods. Containers should stay sealed and protected from light and moisture to limit degradation.