This is a working overview of counter-ion, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-01-31 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Semax is a synthetic seven-amino-acid peptide whose sequence extends the ACTH(4-10) fragment with a C-terminal proline-glycine-proline tripeptide. The commonly cited sequence is Met-Glu-His-Phe-Pro-Gly-Pro, giving a molecular formula near C37H51N9O10S and a molecular weight close to 813.9 g/mol. It belongs to the broader class of synthetic ACTH fragments studied for central nervous system effects rather than for adrenal steroid stimulation. In practice the material appears as a lyophilized white powder for laboratory work or as a dilute saline solution in clinical settings.
Development is attributed to researchers at the Institute of Molecular Genetics in Moscow during the early 1980s, building on earlier Soviet work with ACTH fragments. Russian regulatory approval followed for intranasal use, and the compound has remained commercially available there for decades. Most published human data originate from Russian and, later, some Eastern European clinical reports, which are not always accessible in English translation. Outside that region the material is generally handled as a research chemical rather than a licensed medicine.
Regulatory status differs sharply between jurisdictions. In Russia the peptide is registered as a prescription nasal preparation, while agencies such as the United States Food and Drug Administration have not approved it for any indication. Products sold elsewhere are typically labeled for laboratory research only, and such labels shift responsibility for safe handling to the purchaser. Because the same name covers pharmaceutical-grade nasal drops and bulk research powder, identity and purity documentation becomes the main practical concern when comparing sources.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Clinical reports describe use in ischaemic stroke, transient ischaemic attack, optic nerve conditions, and cognitive complaints, but most of these studies are small and were conducted in a single region. Systematic reviews have generally described the evidence base as limited in size and variable in methodological quality. Randomised controlled data suitable for international regulatory assessment are scarce. As a result, major treatment guidelines outside Russia do not include the peptide, and interest in it remains largely research-driven rather than routine clinical.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
=== Form === Military grade C-4 is commonly packaged as the M112 demolition block. The demolition charge M112 is a rectangular block of Composition C-4 about 2 by 1.5 inches (51 mm × 38 mm) and 11 inches (280 mm) long, weighing 1.25 lb (570 g). The M112 is wrapped in a sometimes olive color Mylar-film container with a pressure-sensitive adhesive tape on one surface. The M112 demolition blocks of C-4 are commonly manufactured into the M183 "demolition charge assembly", which consists of 16 M112 block demolition charges and four priming assemblies packaged inside military Carrying Case M85. The M183 is used to breach obstacles or demolish large structures where larger satchel charges are required. Each priming assembly includes a five-or-twenty-foot (1.5 or 6.1 m) length of detonating cord assembled with detonating cord clips and capped at each end with a booster. When the charge is detonated, the explosive is converted into compressed gas. The gas exerts pressure in the form of a shock wave, which demolishes the target by cutting, breaching, or cratering. Other forms include the mine-clearing line charge and M18A1 Claymore mine.
==== Dosage and safety margin ==== The data sheets for meloxicam products for cats also state that: "Meloxicam has a narrow therapeutic safety margin in cats and clinical signs of overdose may be seen at relatively small overdose levels."
In ancient warfare, militaries generally lived off the land, relying on whatever food they could forage, steal, purchase, or requisition. Armies that brought food supplies along with them would have to resort to carrying them in baggage trains and having soldiers carry their rations themselves. In Mesopotamia, most workers, including soldiers, were given rations of barley, oil, and wool. The first standing army in recorded history formed in ancient Mesopotamia under the reign of Sargon of Akkad, and as the army grew with his conquests, a military bureaucracy formed. According to letters from the time of Sargon II, the primary ration for his army was grain. The letters describe what types of grain are to be held for a campaign, in which locations, which grain to give to the soldiers and which to store as fodder for the pack animals, and provide lists of how much grain to give to the soldiers of specific ranks. In ancient Egypt, soldiers brought whatever they could carry in battle, but were provided with good food and wine while in their camps. Archaeologists have discovered small wooden tokens dating from the Middle Kingdom period carried by soldiers which were to be handed over in exchange for rations in Lower Nubia. The tokens carry inscriptions declaring the amount of bread a soldier is to be issued every ten days. Writing in Histories, Herodotus described warriors serving as the Pharaoh's bodyguards receiving a daily provision of five minae of roast grain, two minae of beef, and four cups of wine. One mina is equivalent to approximately 1.25 pounds (570 g).
Sources: en.wikipedia.org
ABC transporters utilize the energy of ATP binding and hydrolysis to transport various substrates across cellular membranes. They are divided into three main functional categories. In prokaryotes, importers mediate the uptake of nutrients into the cell. The substrates that can be transported include ions, amino acids, peptides, sugars, and other molecules that are mostly hydrophilic. The membrane-spanning region of the ABC transporter protects hydrophilic substrates from the lipids of the membrane bilayer thus providing a pathway across the cell membrane. Eukaryotes do not possess any importers. Exporters or effluxers, which are present both in prokaryotes and eukaryotes, function as pumps that extrude toxins and drugs out of the cell. In gram-negative bacteria, exporters transport lipids and some polysaccharides from the cytoplasm to the periplasm. The third subgroup of ABC proteins do not function as transporters, but are rather involved in translation and DNA repair processes.
Drug titration is the process of adjusting the dose of a medication for the maximum benefit without adverse effects. When a drug has a narrow therapeutic index, titration is especially important, because the range between the dose at which a drug is effective and the dose at which side effects occur is small. Some examples of the types of drugs commonly requiring titration include insulin, anticonvulsants, blood thinners, anti-depressants, and sedatives. Titrating off of a medication instead of stopping abruptly is recommended in some situations. Glucocorticoids should be tapered after extended use to avoid adrenal insufficiency. Drug titration is also used in phase I of clinical trials. The experimental drug is given in increasing dosages until side effects become intolerable. A clinical trial in which a suitable dose is found is called a dose-ranging study. Therapeutic drug monitoring Pituri – chewed as a stimulant (or, after extended use, a depressant) by Aboriginal Australians
== Promethium-147 == Promethium-147 beta decays to the long-lived primordial radioisotope samarium-147 with a half-life of 2.6234 years, emitting low-energy beta radiation without gamma emission. It is a common fission product, produced in nuclear reactors and in trace quantities in nature, where it is also produced by the alpha decay of europium-151. In the reactor environment, it is almost exclusively produced through beta decay of neodymium-147 as usual for fission products. The isotopes 142-146Nd, 148Nd, and 150Nd are all stable with respect to beta decay, so the isotopes of promethium with those masses are not produced by beta decay and are therefore not significant fission products (as they could only be produced directly, rather than through a beta-decay chain). 149Pm and 151Pm are, but have half-lives of only 53.08 and 28.40 hours, so are not found in spent nuclear fuel that has been cooled for months or years. Promethium-147 is used as a beta particle source and a radioisotope thermoelectric generator (RTG) fuel; its power density is about 2 watts per gram. Mixed with a phosphor, it was used to illuminate the Apollo Lunar Module electrical switch tips and the control panels of the Lunar Roving Vehicle. For luminescent applications, it has generally been replaced by tritium, which is even safer and has a longer half-life (12.32 years).
to improve glycemic control when metformin and/or sulphonylurea (SU) and empagliflozin or linagliptin do not provide adequate glycemic control; when already being treated with the free combination of empagliflozin and linagliptin.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is a short synthetic peptide built from seven amino acids: methionine, glutamic acid, histidine, phenylalanine and three prolines. The sequence derives from the 4-10 fragment of adrenocorticotropic hormone with an added proline-glycine-proline tail. No plant or animal extract is involved; the material is produced by solid-phase peptide synthesis.